Issue in interfacing E-Ink display with STM8S103F3P6 microcontroller - c

Question

I am using Waveshare 1.54" ePaper Module. Using SPI peripheral:
CPU freq is 16Mhz
SPI Prescaler DIV by 8
MSB FIRST
CPOL=0, CPHA=1
The Display does not response but it respond with TI CC1310 properly.
The problem with SPI is after transmitting byte it does not go to ideal high state.
I have checked with logic analyser.
The SPI is initialised thus:
/****************** Initializing The SPI Peripheral ******************/
void SPI_setup(void)
{
CLK_PeripheralClockConfig(CLK_PERIPHERAL_SPI, ENABLE); //Enable SPI Peripheral Clock
//Set the MOSI, MISO and SCk at high Level.
//GPIO_ExternalPullUpConfig(GPIOC, (GPIO_Pin_TypeDef)(GPIO_PIN_6),ENABLE);
SPI_DeInit();
SPI_Init(SPI_FIRSTBIT_MSB, //Send MSB First
SPI_BAUDRATEPRESCALER_8, //Fosc/16 = 1MHz
SPI_MODE_MASTER,
SPI_CLOCKPOLARITY_LOW, //IDEAL Clock Polarity is LOW
SPI_CLOCKPHASE_2EDGE, //The first clock transition is the first data capture edge
SPI_DATADIRECTION_2LINES_FULLDUPLEX, //Only TX is Enable
SPI_NSS_SOFT,
0x00);
SPI_Cmd(ENABLE);
}

Answer 1

This is pretty much the same problem you had at Issue in interfacing SPI e-ink display with PIC 18F46K22 only on a different processor. Worth noting that CPHA on STM8 has the opposite sense to CPE on PIC18 which may be the cause of your error. That is to say that CPHA=1 on the STM8 has the same effect as CKE=0 on the PIC18. You really have to look at the timing diagrams for each part carefully.
From https://www.waveshare.com/wiki/1.54inch_e-Paper_Module:
Compare with the STM8 reference manual:
Clearly you need one of:
CPHA=1 / CPOL=1 (SPI_CLOCKPOLARITY_HIGH / SPI_CLOCKPHASE_2EDGE) or
CPHA=0 / CPOL=0 (SPI_CLOCKPOLARITY_LOW / SPI_CLOCKPHASE_1EDGE)
If it is the SCLK that you want to be normally-high, then you need the first option - although I fail to see why that is "ideal", the Waveshare diagram clearly indicates that either is acceptable.